al mag_sensor ms Trendsetter_400/800_Auto Trendsetter_NEWS When set (1), this flag enables checking of the sensors which determine if the Trailing Edge (TE) clamps are on the actuator. When cleared, (0), the sensor is by-passed and the state al te flag is used to keep track of where the TE clamps are. byte
  • 1
    •
  • 0 to 1
    •      If this flag is cleared, (0), machine operation is significantly slowed down and some critical safety checks are not done. Clearing this flag should only be done on a temporary basis and the sensor should be repaired as soon as possible. Please do not clear this flag unless absolutely necessary! This flag was previously named "nms" in other products. cal
  • ../commands/engine.xmlCommand: engine
    •
  • ..\..\ShowAllErrors.htmFirmware 0 Error Index
  • ..\..\ShowAllCommands.htmFirmware 0 Command Index
  • ..\..\ShowAllNVS.htmFirmware 0 NVS Index
    •  Updated: Wed Jul 16 19:35:36 2008 PST